Additional file 1: Table S1 summarizes the values of central wavelength and
stop band width of the spectra. By comparing the ranges in the spectra not corresponding to a stop band, it can be concluded that the transmittance for N C = 150 is lower than for N C = 50. This difference can be attributed to scattering Tideglusib clinical trial losses caused by the irregular interfaces between each cycle. Finally, there is a clear difference between the central wavelength of the stop bands, which is lower for the sample produced at the lower temperature, N C = 150 and T anod = 7°C. selleck compound Figure 2 Comparison of the spectra of samples obtained with N C = 50 cycles (a) and N C = 150 cycles (b). In order to evaluate more precisely this dependence of the stop band central wavelength with the temperature, Figure 3 shows the transmittance spectra for samples produced with temperatures T anod = 8, 9, 10, and 11°C and after different times of pore widening, t PW = 0, 9, 18, and 27 min. The spectra show similar trends as the observed in Figure 2: for the as-produced samples, the spectra show truncated stop bands that become better defined with the pore-widening process. At the same time, the pore widening causes a decrease in the central wavelength as it decreases
the overall effective refractive selleck kinase inhibitor index of each cycle in the DBR. Additional file 1: Table S2 reports the values of stop band central wavelength and stop band width for the spectra. The spectra
in Figure 3 show that the main influence of the anodization temperature is in the stop band central wavelength, while other features such as the depth of the stop band transmittance minimum or the difference in shape observed for the as-produced samples are less influenced by T anod. Figure 3 Comparison of the spectra of samples obtained at different anodization temperatures and after different pore-widening times. The dependence of the central wavelength with the anodization temperature is summarized in Figure 4, Cediranib (AZD2171) where the different central wavelengths of the first-order stop band are plotted as a function of the pore-widening time. The data in Figure 4 demonstrate that by a precise control of the temperature and of the pore-widening time, the stop band central wavelength can be modulated between 500 and 820 nm. The curves for the different temperatures show the same behavior, what indicates that carrying the anodization at a different temperature does not influence the pore-widening rate in the subsequent pore-widening process. It is also important to mention that the intervals between the curves in Figure 4 are constant, what indicates that the shift of the central wavelength with the temperature is uniform with an estimated average value of 42.5 nm/°C (see Additional file 1: Figure S2). Table 1 shows the average stop band width for the different pore-widening times and the corresponding standard deviation.