05. (D) Isotherm plots at Re = 100 and (a) φ = 0.0 and (b) φ = 0.05. The streamlines show that as the Reynolds number increases, the vortices that are formed behind the fins become larger and stronger.

This can be more clearly illustrated in Figure 5 where the horizontal velocity in the middle section between fins is presented. At Re = 10, the velocity is consistently positive. However, as the Reynolds number increases, the flow velocity becomes negative. This is an indication of #selleck chemicals randurls[1|1|,|CHEM1|]# flow reversal. The strong vortex at high numbers enhances the heat transfer from left face objects to right face objects and the wall between the two fins. This difference, however, becomes noticeable at higher Re. At low Reynolds numbers, the conduction is the dominating mechanism of heat transfer. Therefore, the isotherms stretch above the fins and take a

large area in the channel. As Re increases, the convection becomes the dominating mechanism, and the strong cold inlet flow pushes the isotherms near the bottom wall. The comparison Buparlisib price between the isotherms of the nanofluid and pure water shows that in each point of the channel, the nanofluid temperature is higher than the pure water. It is due to the nanofluid’s higher thermal conductivity. The current investigation is wrapped with the analysis of the effect of the Reynolds number and percentage of nanoparticle volume fraction on the heat transfer enhancement in the channel. Figure 7 and Table  1 display values of average Nusselt number at various Reynolds numbers and solid volume fraction from 0% to 5%. These figures demonstrate that the Nusselt number clonidine increases with the Reynolds number for values of volume fraction tested in the present study. For example, at Re = 100, in the addition of volume fraction of 5%, the average Nusselt number increases about 17%. High Reynolds number results in high energy transport through the fluid and cause irregular motion of nanoparticle. The higher solid volume fraction further stimulates the

flow and contributes to higher Nusselt number as shown in the figure. The presence of nanoparticles also increases the rate of heat transfer by conduction mode through the flow. Figure 7 Average Nusselt number for various Re. Table 1 Average Nusselt number for various Reynolds number and solid volume fraction Reynolds number Average Nusselt number φ = 0.0 φ = 0.03 φ = 0.05 Re = 10 Nuave 2.712 2.826 2.965 Re = 50 Nuave 5.294 5.683 5.919 Re = 100 Nuave 10.252 10.797 11.109 Conclusions LBM was applied to simulate forced convection heat transfer in two-dimensional channel including extended surfaces to investigate the effect of changing different parameters such as Reynolds number (10, 50, and 100) and nanofluid (Al2O3) volume fractions (0.0, 0.03, and 0.05). The results showed that as the Reynolds number increases, the rate of heat transfer also increases. The formation of vortices both in front and behind the objects enhances the heat transfer process.