This is primarily due to the adsorption kinetic of the CO2 molecules (10−8 to 10−3 s) on TiO2 being slower

than the electron–hole recombination time (10−9 s) [47, 54]. In addition, the two-dimensional and planar π-conjugation structure of rGO endowed it with excellent conductivity of electron [16, 55]. As we know, one photon can usually induce the transfer of only one electron in photochemical reactions. However, the photocatalytic reduction of CO2 required a multi-electron process to yield CH4.Therefore, in the rGO-TiO2 composite, rGO served as an electron collector and transporter to effectively separate the photogenerated electron–hole pairs. This in turn lengthened the lifetime of the charge carriers, which could be advantageous for overcoming this obstacle

Cediranib nmr to improve the selective formation of CH4 gas. During the photocatalytic reaction, a large number of electrons would be produced due to the highly dispersed TiO2 HM781-36B manufacturer nanoparticles over the rGO sheets (see Figure 2a,b). Furthermore, the large specific surface area of rGO also increased the adsorption of the CO2 molecules, thus favoring the formation of CH4. The mechanisms of photocatalytic enhancement over the rGO-TiO2 composite are depicted in Figure 8. Figure 8 Charge transfer and separation in the rGO-TiO 2 composite. Schematic illustrating the charge transfer and separation in the rGO-TiO2 composite for the photoreduction of CO2 under visible light irradiation with the introduction of a new energy level, E F *. The photocatalytic conversion of CO2 to CH4 over the rGO-TiO2 composite can be understood using the energy band theory, which is based on the relative positions of CB, VB, and selleck screening library oxidation potentials. In general, the overall mechanism of the CO2 transformation process is a sequential combination of H2O see more oxidation and CO2 reduction. In the rGO-TiO2 composite,

the TiO2 nanoparticles exhibited an intimate contact with the rGO sheet. The d orbital (CB) of TiO2 and the π orbital of rGO matched well in energy levels, thus resulting in a chemical bond interaction to form d-π electron orbital overlap [56]. The CB flatband potential of TiO2 is −0.5 V (vs. normal hydrogen electrode (NHE), pH = 7) [57], which is more negative than the reduction potential of CO2/CH4 (−0.24 V vs. NHE, pH = 7) [58] acts as a donor. This indicated that the photogenerated electrons and holes on the irradiated rGO-TiO2 composites can react with adsorbed CO2 and H2O to produce CH4 via an eight-electron reaction. The major reaction steps in the photocatalytic CO2 reduction process can be summarized by Equations 1, 2 and 3 (1) (2) (3) Conclusions In summary, a visible-light-active rGO-based TiO2 photocatalyst was developed by a facile, one-pot solvothermal method. To control the hydrolysis reaction rate of water-sensitive TBT, we employed EG and HAc mixed solvent coupled with an additional cooling step in our synthesis procedure.